Call Number (LC) Title Results
Y 3.N 21/5:6/2985 A flight investigation of the effect of steady rolling on the natural frequencies of a body-tail combination / 1
Y 3.N 21/5:6/2986 Effect of blade-thickness taper on axial-velocity distribution at the leading edge of an entrance rotor-blade row with axial inlet, and the influence of this distribution on alignment of the rotor blade for zero angle of attack / 1
Y 3.N 21/5:6/2987 Charts relating the compressive buckling stress of longitudinally supported plates to the effective deflectional and rotational stiffness of the supports / 1
Y 3.N 21/5:6/2988 Temperatures, thermal stress, and shock in heat-generating plates of constant conductivity and of conductivity that varies linearly with temperature / 1
Y 3.N 21/5:6/2989 Comparison of secondary flows and boundary-layer accumulations in several turbine nozzles / 1
Y 3.N 21/5:6/2990 Flight measurements and analysis of helicopter normal load factors in maneuvers / 1
Y 3.N 21/5:6/2991 Accelerations and passenger harness loads measured in full-scale light-airplane crashes / 2
Y 3.N 21/5:6/2992 Application of a characteristic blade-to-blade solution to flow in a supersonic rotor with varying stream-filament thickness / 1
Y 3.N 21/5:6/2993 Calibration of strain-gage installations in aircraft structures for the measurement of flight loads / 1
Y 3.N 21/5:6/2994 Column strength of H-sections and square tubes in postbuckling range of component plates / 1
Y 3.N 21/5:6/2995 New experiments on impact-pressure interpretation in supersonic and subsonic rarefied air streams / 1
Y 3.N 21/5:6/2996 Appraisal of hazards to human survival in airplane crash fires / 1
Y 3.N 21/5:6/2997 Application of several methods for determining transfer functions and frequency response of aircraft from flight data / 1
Y 3.N 21/5:6/2998 The effects of camber on the variation with Mach number of the aerodynamic characteristics of a 10-percent-thick modified NACA four-digit-series airfoil section / 1
Y 3.N 21/5:6/2999 Impingement of droplets in 90 degree elbows with potential flow / 1
Y 3.N 21/5:6/3000 Studies of the use of Freon-12 as a wind-tunnel testing medium / 1
Y 3.N 21/5:6/3001 Comparison of operating characteristics of four experimental and two conventional 75-millimeter-bore cylindrical-roller bearings at high speeds / 1
Y 3.N 21/5:6/3002 Effect of bronze and nodular iron cage materials on cage slip and other performance characteristics of 75-millimeter-bore cylindrical-roller bearings at DN values to 2,000,000 / 1
Y 3.N 21/5:6/3003 Investigation of 75-millimeter-bore deep-groove ball bearings under radial load at high speeds. : 2 - Oil inlet temperature, viscosity, and generalized cooling correlation. / 1
Y 3.N 21/5:6/3004 Theoretical performance characteristics of sharp-lip inlets at subsonic speeds / 1